Probleme voyant batterie sur F4 de 2008 - Page 2

19/06/2012, 06h14

j 'ai vérifié dans une documentation technique les tensions sont bonnes.

**titi10r** · 19/06/2012, 08h08

infos données dans la notice d'atelier:

Charge feed check
• Remove the tail unit • Switch on the engine and run it at 2000 r.p.m. with
the light switch in the “ON” position and the selector on main beam Hl.
Measure the voltage between the positive (+) and negative (-) terminals of the battery with a multi-tester. If the tester indicates less than 12.6V or more than 14.3V the cause will be found in the generator.
N.B. When carrying out this check, ensure that the battery is fully charged.
Standard recharge voltage: 12.6 - 14.3V at 2000 r.p.m.

19/06/2012, 16h55

oui je suis d'accord , mais a la page 21 de la notice technique il ya ça:

Electrical system
A list of possible problems that could occur when the warning light is switched on.

With the engine switched on at approximately
2000 r.p.m. check the voltage of
the battery (all utilities must be switched
off and the regulator at 25°C.); the voltage
must be 14.5V ± 0.6.
N.B. At different temperatures the voltage
can be between 13V and 15.5V.

merci pour l'info

19/06/2012, 08h08	#5
titi10r Rang 5 - Phil Read brutale 1078rr Date d'inscription: mai 2011 Localisation: près de Toulon Messages: 701 Voir ma localisation	infos données dans la notice d'atelier: Charge feed check • Remove the tail unit • Switch on the engine and run it at 2000 r.p.m. with the light switch in the “ON” position and the selector on main beam Hl. Measure the voltage between the positive (+) and negative (-) terminals of the battery with a multi-tester. If the tester indicates less than 12.6V or more than 14.3V the cause will be found in the generator. N.B. When carrying out this check, ensure that the battery is fully charged. Standard recharge voltage: 12.6 - 14.3V at 2000 r.p.m. __________________ quant à la brutale, trop, c'est trop (bon)

19/06/2012, 06h14	#4
312r974 Guest Messages: n/a	j 'ai vérifié dans une documentation technique les tensions sont bonnes.

19/06/2012, 16h55	#6
312r974 Guest Messages: n/a	oui je suis d'accord , mais a la page 21 de la notice technique il ya ça: Electrical system A list of possible problems that could occur when the warning light is switched on. With the engine switched on at approximately 2000 r.p.m. check the voltage of the battery (all utilities must be switched off and the regulator at 25°C.); the voltage must be 14.5V ± 0.6. N.B. At different temperatures the voltage can be between 13V and 15.5V. merci pour l'info